Hard Enduro engine guard 950/990ADV. – Twalcom®

Hard Enduro engine guard 950/990ADV. – Twalcom®


SKU: AA.02.01680.002.003 Categories: , ,


Special Tester  ” Francesco Catanese “.   Hellas Rally, Baja Aragon, Transanatolia Rally and Italian Motorally Championship 2013  are just some of the situations in which our product has been tested and without any failure.

This sturdy engine guard of 8 mm. thickness has been specifically designed to be able to make the  950/990ADV able to face any Hard Enduro situation. It was designed to provide maximum protection in frontal impact, allowing for complete protection of the engine block as well as backward and raise the point of frontal impact of about 15 cm.

During the design was also devoted particular attention to heat dissipation. With the bike moving , large front and side eyelets help to increase the outflow of heat, while the wide rear slot and plenty of space at the sides allow easy cleaning of the engine block. Mud and dirt that may accumulate during the most challenging off-road situations will be eliminated quickly and easily.

In addition to this the large free space between the engine guard and the engine block can be used for the positioning of a possible tool kit (type Kriega Toll Roll cod. KR.04.01070.089.000).

The Hard Enduro engine guard is built with quality materials and comes complete with anti-vibration elastic supports, brackets and stainless steel screws with self-blocking .

Structure: Peralluman 8 mm.

Instructions: clear instructions in Italian with photos. Warning: Mounting of the Hard Enduro engine guard necessarily require the relocation of the battery in another position.



There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.